Remove TCU
1. Step
Select Toolbox
Select BCM customization
Click on the Telematic Control Module
Click on the button change (blue arrow) for new value
and click on the Confirm button (Green arrow)
2. Step
- Turn Ignition OFF
- Disconnect and remove TCU
note: Remove main fuse and follow the service manual
3. Step
- Turn Ignition ON
- Go to Diag4Bike -> BCM Customization->Telematic Control Unit -> Not Installed _> Green arrow
4. Step
- Cycle ignition
- Start Engine
note:
If engine start the proccedure is OK. -> Turn Ignition OFF
If engine not start -> Repeat the TCU Deactivation and Removal Procedure.