2.1. Preparation of the motorcycle

2.1.  Preparation of the motorcycle

Before starting any tuning, in which you are going to modify the engine control system, you need to:
  • Check the functions of the motorcycle systems using the Motorcycle report diagnostic function of theDiag4Bike™  and perform a detailed check of the EFI system through measured parameters. A fault in any motorcycle control module may compromise communication via the diagnostic line used for the tuning operations.
  • Check for proper function of spark plugs by checking flash-over voltage, which must be below 10 kV at idle RPM. If you don’t have ability to measure this and the mileage of plugs is over 5,000 kilometres (3,000 miles), carry out preventive replacement. While checking the plugs, check also the ignition cables and ignition module.
  • Replace or wash the air filter.
  • Ensure reliable power supply to the dash board network by checking the battery of the motorcycle. If low battery capacity is identified, replace the battery or provide continuous external charging.
  • Check whether any tuning device has been mounted and if so, it must be disconnected from the EFI control module, especially from the diagnostic line.
  • Check whether tuning of the model and year of manufacture is supported by the Diag4Tune™ tool. Insert the tuning dongle to the USB connector (Tuning Dongle)

                                                                                                                                        

Clipboard09

Connect Diag4Bike to motorcycle and make sure, that the battery is well charged. For sure you can conncet battery charger

Button video

Comments are closed.