Front and Rear turn signal



Click on the button (blue arrow) for change value and button (green arrow) for confirm.




When changing from incandescent to LED turn signals, the indicator light may flash fast.

Synchronization some Led turn lights, proceed as follows :


Pressing Hazard switch. The BCM ignores the first 8 hazard flashes and next 8 hazard flashes the BCM learns. After 16 hazard flashes are updated in the BCM.


If this process is not successful, try the following process:


Turn Ignition on, but do not start
the bike.

Turn on 4 way hazards by pressing
the hazard button on the controls.

Turn the Ignition off letting
hazards run. If the bike has security they will flash 5 or 6 times and then
pause. This is normal. They will go back to flashing normal hazard mode.

Let hazards run 1-2 minutes.

Turn Ignition back on.

Turn off hazards.

Turn Ignition off and then back on.

Check function of both turn

Los comentarios están cerrados.